Atlanta, Georgia · serving dealers and manufacturers nationwide (404) 303-8575  ·  toll free 1-877-909-8575

Fastener line

R4 multi-purpose screws

The patented R4 head carries six cutting pockets that work like circular saw blades, so the screw countersinks itself as it drives.

Countersinking without a countersink

The patented R4 features six cutting pockets beneath its head. As the screw drives, those pockets act like circular saw blades and cut a clean seat for the head — which means effortless countersinking, even in dense decking and hardwoods, without a separate bit change or a hammer tap.

The result is a head that sits below the surface on the first pass, a deck board that is not crushed around the fastener, and a crew that does not spend the afternoon backing screws out.

The general-purpose line

R4 is the line we recommend when the job is not quite structural and not quite finish: decking, subfloor, fencing, crating, general assembly. It carries the same Torx® drive and Climatek® coating as the rest of the range, and the same W-Cut thread for a fast start in hardwood and composite.

Where the head has to vanish completely, step up to the trim head. Where the connection carries load, use the RSS structural screw.

Features

  • Patented R4 head with six cutting pockets
  • Self-countersinking — no separate countersink bit
  • Torx® drive with a clean, non-camming seat
  • Climatek® coating for exterior work
  • W-Cut thread for fast starts and less splitting

Where it is used

The applications this line was designed for, in the words of the crews who buy it.

Ordering this line

Available in BULK, PRO PAK, CONTR. PAK and HANDY PAK, subject to the size chart for the item.

Typical applications
ApplicationWhat it solves
DeckingClean countersink in wood and composite boards.
General-purpose assemblyThe default screw for framing and site work.
Subfloor and sheathingFast driving without crushing the panel.
Fencing and outdoor structuresCoated for weather exposure.
Crating and palletsHigh-volume driving with fewer stripped heads.

Sizes, packs and site notes

Choosing R4 or trim head

Both lines drive with the same bit and both are coated for exterior use. The difference is the head: R4 cuts its own countersink and leaves a small, clean hole; trim head is smaller again and is normally plugged or filled for a true finish appearance.

R4 is stocked in BULK, PRO PAK, CONTR. PAK and HANDY PAK. Sizes and carton quantities are confirmed on the quote.

On site

  • Let the head cut its own seat — do not pre-countersink.
  • Match the driver torque to the material; composite boards vary widely.
  • Keep bits fresh: a rounded Torx® bit ruins the cutting pockets' advantage.
  • Order the GRK bit holder with the first carton.

Related lines

Frequently ordered with this one.

Order desk

Price this line for your next order

Send the size, pack and quantity. Quotes for stock items are normally returned the same business day.